ATX & ATX(12V)
FSP300-60GT
|
Total Power |
300W |
|
Input Voltage |
90~132VAC
180~264VAC |
|
# of Outputs |
6 |
|
Dimension: |
205 X 90 X 41 (mm) |
|
 |
|
FEATURES |
- High efficiency
- Low noise and ripple
- Output over voltage protection
- Short circuit protection on all
outputs
- Resettable power shut down
- Approved by UL 1950, CSA 22.2
Level 3,TUV EN60950 OR VDE EN60950, IEC 950, NEMKO EN 60950, CE
- Internal 40mm 12 VDC fan provided
- Complies with FCC part 15 subpart J
class B 115 VAC operation and CISPR 22 Class 'B' 230 VAC operation
- 100% burn-in under high ambient
temperature (50 degree C)
- MTBF above 100,000 hrs at 25 degree
C
|
|
ELECTRICAL
SPECIFICATIONS |
|
INPUT |
- Voltage: 90-132 VAC or 180-264 VAC
switchable
- Frequency: 48Hz to 63Hz
- Input current: 7.0A (RMS) for 115
VAC, 4.0A (RMS) for 230 VAC
|
|
OUTPUT |
|
OUTPUT |
VOLTAGE |
MINIMUM LOAD |
MAXIMUM LOAD |
LOAD REG. |
RIPPLE (MAX) |
|
1 |
+3.3V |
0.2A |
14A |
±3% |
50mV P-P |
|
2 |
+5V |
1.5A |
30/22A |
±4% |
50mV P-P |
|
3 |
+12V |
0.0A |
12A |
±5% |
120mV P-P |
|
4 |
-12V |
0.0A |
0..2A |
±5% |
150mV P-P |
|
5 |
-5V |
0.0A |
0.3A |
±5% |
150mV P-P |
|
6 |
+5Vsb |
0.0A |
0.8A |
±5% |
50mV P-P |
|
- +3.3V & +5V total output not exceed
150W
|
|
TECHNICAL SPECIFICATION |
- Temperature Range: Operating 0C -
50C; Non-operating: -20C - 80C
- Temperature coefficient: 0.01%C
- Transient Response: Output voltage
returns in less than 1 ms max. following a 25% load change
- Hold up time: 16ms maximum at full
load & nominal input voltage
- Dielectric withstand: Input/output
1800 VAC for 1 second input to frame ground 1800 VAC for 1 second
- Humidity: 5-95% RH
- Efficiency: 65% Min, 70% typical ,
at full load
- Power good signal: On delay 100ms
to 500ms, off delay 1 ms
- Overload protection: 150% Max
- Inrush current: 45A max. for 115
VAC or 80A max for 230 VAC at 25C ambient cold start
- Over voltage protection: +5V
output: 6V+- 0.5V ; +3.3V output: 4V+- 0.5V
|
|
SAFETY SEALS |
|
|
|
MECHANICAL DRAWINGS |
- For Detail Design Drawing and Safety
Certificates, please e-mail us.
|
