Home
About Powertech
Products Contact
Us Whats
New Request For Quote
Technical
Support
Home
About Powertech
Products Contact
Us Whats
New Request For Quote
Technical
Support
 |
PS/III FSP145-60SP |
Features
| · | High efficiency |
| · | Low noise and ripple |
| · | Output over voltage protection |
| · | Short circuit protection on all outputs |
| · | Resettable power shut down |
| · | Approved by UL 1950, CSA 22.2 Level 3, IEC 950, TUV EN60950 |
| · | Internal 12 VDC fan provided |
| · | Complies with FCC part 15 subpart J class B 115 VAC operation and CISPR 22 230 VAC operation |
| · | 100% burn-in under high ambient temperature (50° C) |
| · | MTBF above 100,000 hrs at 25° C |
Input Characteristics
| · | Voltage: 90-132 VAC or 180-264 VAC switchable |
| · | Frequency: 47Hz to 63Hz |
| · | Input current: 4.0A(RMS) for 115 VAC, 2.0A(RMS) for 230 VAC |
Specification
| · | Temperature range: operating 0° C~50° C; Non-operating: -20° C~65° C |
| · | Temperature coefficient: 0.01%/° C |
| · | Transient response: Output voltage returns in less than 1 ms max. following a 25% load change |
| · | Hold up time: 16ms minimum at full load & nominal input voltage |
| · | Dielectric withstand: Input to frame ground 1800 VAC for 1 second |
| · | Humidity: 90~95% RH |
| · | Efficiency: 60% Min., at full load |
| · | Power good signal: Power on delay time 100 ms to 500 ms, power fail ≧ 1 ms |
| · | Overload protection: 150% Max. |
| · | Inrush current: 30A max. for 115 VAC or 60A max. for 230 VAC at 25° C ambient cold start |
| · | Over voltage protection: |
| +3.3V | output: | 4.5V max |
| +5V | output: | 6.5V max |
| +12V | output: | 15 V max |
Remote ON/OFF Control
| · | The power supply shall accept a logic open collector level which will disable/enable all the output voltage. (exclude +5V stand by) |
| · | As logic level is low, output voltages were enabled. |
| · | As logic level is high, output voltages were disabled. |
|
MINIMUM LOAD |
NORMAL LOAD |
MAXIMUM LOAD |
LOAD REG. |
LINE REG. |
RIPPLE & NOISE |
|
|
*+3.3V |
0.2A |
5.0A |
0.2A/10A |
± 5% |
± 1% |
50mV P-P |
|
+5V |
2.0A |
5.0A |
18A/10A |
± 5% |
± 1% |
50mV P-P |
|
*-5V |
0.0A |
0.1A |
0.2A |
± 5% |
± 2% |
100mV P-P |
|
+12V |
0.2A |
2.0A |
4.2A |
± 5% |
± 1% |
100mV P-P |
|
-12V |
0.0A |
0.15A |
0.3A |
± 10% |
± 2% |
120mV P-P |
|
+5Vsb |
0.0A |
0.4A |
0.8A |
± 5% |
± 1% |
50mV P-P |
*+3.3V & +5V total
output not excel 90 watts.
*-5V is OPTIONAL
Safety
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |